Configuration
4.4 Basic settings
TIM 1531 IRC
58 Operating Instructions, 02/2018, C79000-G8976-C468-02
–
Application of the master station PC
The application that you configure in the PC station of the master station.
For the TIM and the assigned CPU, the subscriber number is configured in the
"Subscriber numbers" parameter group of the TIM.
For the application of the master station PC, the subscriber number is configured in the
telecontrol connection: "Network data" editor > "Telecontrol" tab
●
For every networked serial interface in a classic ST7 network a WAN address is
assigned. It is unique in the respective WAN network.
Since telecontrol connections can run via several network nodes and node stations,
unique addressing of the interfaces involved is necessary.
The WAN address is configured in the parameter group "WAN parameters" of the serial
interface.
Configuration
Telecontrol configuration
This is where you specify whether you want to freely configure the module or whether you
want to import the configuration data of a proxy module to expand a STEP 7 V5 project.
● Configure
The subscriber data and SINAUT connections are configured in the parameter groups of
the module and in the connections editor of STEP 7 Professional.
● Import
The configuration data of the proxy module fro, STEP 7 V5 is imported into the module in
STEP 7 Professional.
You can perform the import yourself in the parameter group Partner stations (Page 80).
To expand STEP 7 V5 projects via proxy modules, see section Expansion of SINAUT
projects (Page 28).
Retentive saving of events
If you use an optional SD card in the TIM, in this parameter group you set the conditions for
saving the values of messages whose data points are configured as an event.
To Next Page
Loading...
Need help?
General
