Siemens TIM 1531 IRC - Ethernet Interface; Ethernet Interface > Address Parameters; Advanced Options; MSC Protocol Settings

Configuration
4.9 Ethernet interface
TIM 1531 IRC
Operating Instructions, 02/2018, C79000-G8976-C468-02
67
4.9
Ethernet interface
4.9.1
Ethernet interface > address parameters
Ethernet interface > Ethernet addresses > IP protocol ...
In the following parameter groups configure the IP address parameters of the Ethernet
interface.
You will find information on configuration in the STEP 7 information system.
Ethernet interface > Port [Xn P1]
You will find information on configuration in the STEP 7 information system.
4.9.2
Advanced options
4.9.2.1
MSC protocol settings
The following descriptions apply to the MSC-specific parameter groups of the two interface
types of the TIM.
For information on each of the following parameter groups "TCP connection monitoring" and
"Port" see section Ethernet interface (Page 67).
MSC protocol settings - Ethernet: MSC master station
The description applies to the parameter group of the Ethernet interface with the Network
node type "Master station".
Access to MSC master station
First, specify whether the MSC center or the router should be available via DNS, a fixed or a
dynamic IP address.
The MSC master station is connected to the Internet via a router.