Siemens TIM 1531 IRC - Binary Value Typical Bin04 B_S

Block library TeleControl ST7
5.7 Master copies
TIM 1531 IRC
168 Operating Instructions, 02/2018, C79000-G8976-C468-02
Range of va
l-
ues
:
I/O words
Memory words
Data words
PQW0 ... PQWn
MW0 ... MWn
LW0 ... LWn
DBm.DBW0 ... n
You can select where the individual analog values received by the FB are
output. I/O words from analog output modules, data words from a data block
and memory words
can be mixed as required.
If you do not require parameters, simply leave them open.
Parameter:
NewData
For the declaration, data type, range of values, default and function, refer to
the section Reoccurring parameters (Page 144).
Typical
-
specific r
e-
sponse:
Whenever the FB has received new data and has output it to the outputs
"AnalogOutput_1" to "AnalogOutput_4", the "NewData" output is set to
TRUE
for one OB1 cycle.
5.7.1.8
Binary value typical Bin04B_S
Function
Send 4 bytes of binary information
Parameter
Parameter:
PartnerNo
PartnerObjectNo
Enabled
ImageMemory
Conditional
Unconditional
TimeStamp
For a description, see section Reoccurring parameters (Page 144).
Parameter:
InputByte_1 … _4
Declaration:
INPUT
Data type:
BYTE
Range of
values:
See address range
Default:
0 (B#16#0)