Siemens TIM 1531 IRC - Page 221

Block library TeleControl ST7
5.7 Master copies
TIM 1531 IRC
Operating Instructions, 02/2018, C79000-G8976-C468-02
221
Range of
values:
See address range.
Default:
0 (W#16#0)
Address
range:
Output words
QW0 ... QWn
PQW0 ... PQWn
Memory words
MW0 ... MWn
LW0 ... LWn
Data words
DBm.DBW0 ... n
Explanation:
Output for a returned setpoint
The partner object receiving the setpoint reports back the currently valid se
t-
point th
ere. This value is displayed at the "ReturnedSetpoint" output.
If the partner object is set to 'local' and a new input is made there, the setpoint
changed locally is indicated here by "ReturnedSetpoint".
After startup of the local or partner CPU, or after
restoring a connection, an
automatic general request ensures that the locally valid setpoint is indicated
by "ReturnedSetpoint".
If you do not require the parameter, simply leave it open.
Parameter:
LocalOperation
Declaration:
OUTPUT
Data type:
BOOL
Range of
values:
TRUE / FALSE
Default:
FALSE
Address
range:
Output
Q 0.0 ... Q n.7
Memory bit
M 0.0 ... M n.7
L 0.0 ... L n.7
Data bit
DBm.DBX 0.0 ... n.7
Explanation:
Return message from the partner object: The object is set to local operation.
A s
etpoint can also be set locally at the partner object that receives the set-
point. The partner object Set01W_R must then be set to ’local’ at the "Local"
input parameter. The current status of the "Local" input parameter is reported
by the partner object an
d indicated here at the "LocalOperation" output.
After startup of the local or partner CPU, or after restoring a connection, an
automatic general request ensures that the local currently valid status is di
s-
played at "LocalOperation".
If you do not require the parameter, simply leave it open.