Siemens TIM 1531 IRC User Manual

Block library TeleControl ST7
5.7 Master copies
TIM 1531 IRC
240 Operating Instructions, 02/2018, C79000-G8976-C468-02
Name:
EnableMask
Declaration:
INPUT
Data type:
BYTE
Range of
values:
B#16#00 ... B#16#FF
Explanation
Enable mask for the counting inputs
With this parameter "EnableInMask" it
is possible to specify in the form of a bit
mask at which inputs in the input byte count pulses are actually connected.
The following applies to every bit in the bit mask:
•
0 = Input bit blocked for acquisition
•
1 = Input bit enabled for acquisition
The inpu
t of the mask is only permitted in hexadecimal format B#16#00 to
B#16#FF.
Input as an 8
-bit binary number from 2#0 to 2#1111 1111 is not possible with
the data type BYTE.
The assignment of the bits in the mask to the inputs in the input byte "InByte":
InByte
.7
.6
.5
.4
.3
.2
.1
.0
EnableMask B#16#
0 … F
0 … F
Example:
EnableMask B#16#83
Enabled are: Inputs .7, .1 and .0
Blocked are: Inputs .6 to .2
Name:
CntIn_0 ... CntIn_7
Declaration:
INPUT
Data type:
COUNTER
Range of
values:
C0 or C1
... Cn
(n depends on the CPU)
Explanation
Pulse counter
For each of the enabled counting inputs a SIMATIC counter needs to be spe
c-
ified for the corresponding parameter CntIn_0 ... . "CntIn_7". With each pulse
acquired, the SIMATIC counter is incremented.
The counters set here must be specified as input counters (parameter Cou
n-
ter_1 ... _4) in the actual counted value function blocks "Cnt01D_S" and
"Cnt04D_S". These function blocks out read the assigned counter and then
reset it.
As the placeholder for p
arameters that are not required, it is recommended to
specify the counter C0.

Siemens TIM 1531 IRC Specifications

General

Brand	Siemens
Model	TIM 1531 IRC
Category	Controller
Language	English