Siemens TIM 1531 IRC User Manual

Block library TeleControl ST7
5.7 Master copies
TIM 1531 IRC
252 Operating Instructions, 02/2018, C79000-G8976-C468-02
Range of
values:
•
00 ... 99
•
FF
Explanation
Specifies the values for month and year
Each parameter is in two parts. Each of the two values per parameter is spec
i-
fied with two digits as a BCD
-coded value.
•
The first two digits specify the value for hours, seconds or month.
•
The two other digits specify the value for minutes, day or year.
For parts of the parameter that are not needed FF is entered.
Which parameters are permitted depends on the particular paramet
er and on
the "IntervalMode" parameter. You will find further information following the
explanation of the parameters.
Name:
TriggerOutput
Declaration:
OUTPUT
Data type:
BOOL
Range of
values:
Output
Q 0.0 ... I n.7
Memory bit
M 0.0 ... M n.7
L 0.0 ... L n.7
Data bit
DBm.DBX 0.0 ... n.7
Explanation
Trigger output
The output is set for the duration of one OB1 cycle when the time or time i
n-
terval set for "Hour" to "Year" is reached.
Name:
Flag
Declaration:
IN_OUT
Data type:
BOOL
Range of
value
s:
Memory bit
M 0.0 ... M n.7
Data bit
DBm.DBX 0.0 ... n.7
This is an in/out parameter (declaration IN_OUT). It is difficult to specify local
bit memory with this parameter and this should not be used.
Explanation
Edge memory bit for the "TriggerOutpu
t" output.
No placeholder memory bit may be specified!
The edge memory bit must not be reset by the user program.
Examples of the parameter assignment of a time or time interval
IntervalMode = FALSE (or 0)
The FC operates according the time principle. When the time set is reached, the output
"TriggerOutput" is set for one OB1 cycle.
All time parameters can be used to specify the point in time. Parameters not required should
be assigned FF. They are ignored during the check for reaching the time.

Siemens TIM 1531 IRC Specifications

General

Brand	Siemens
Model	TIM 1531 IRC
Category	Controller
Language	English