Siemens TIM 1531 IRC User Manual

Diagnostics and upkeep
7.5 SNMP
TIM 1531 IRC
Operating Instructions, 02/2018, C79000-G8976-C468-02
289
Scope of performance of the TIM as an SNMP agent
The TIM supports data queries in the following SNMP versions:
● SNMPv1 (standard)
● SNMPv3 (Security)
It returns the contents of MIB objects of the standard MIB II according to RFC 1213 and the
Siemens Automation MIB.
●
MIB II
The TIM supports the following groups of MIB objects:
– System
– Interfaces
The "Interfaces" MIB object provides status information about the TIM interfaces.
– IP
– ICMP
– TCP
– UDP
– SNMP
The following groups of the MIB II standard are not supported:
– Adress Translation (AT)
– EGP
– Transmission
●
Siemens Automation MIB
The following exceptions / restrictions apply to the TIM.
Write access is permitted only for the following MIB objects of the system group:
– sysContact
– sysLocation
– sysName
A set sysName is sent as the host name using DHCP option 12 to the DHCP server to
register with a DNS server.
For all other MIB objects / MIB object groups, only read access is possible for security
reasons.
Traps are not supported by the TIM.
For more detailed information about the MIB files and SNMP, refer to the manual /11/
(Page 321).
Configuration
For information on the configuration, refer to the section SNMP (Page 92).

Siemens TIM 1531 IRC Specifications

General

Brand	Siemens
Model	TIM 1531 IRC
Category	Controller
Language	English