Application and functions
1.9 Expansion of SINAUT projects
TIM 1531 IRC
30 Operating Instructions, 02/2018, C79000-G8976-C468-02
Requirements: Software versions
The above-mentioned configuration tools are required in the specified versions for expansion
of SINAUT projects.
●
A configuration file of the communication module from a consistent STEP 7 V5 project is
required.
Requirements: Firmware versions/module update
●
Firmware of the communication module
The following firmware versions of the communication modules used are required:
–
A TIM 1531 IRC V1.0 can be exchanged for a TIM 1531 IRC V1.1 but not the other
way round.
The mode of the "Telecontrol configuration" ("Basic settings") is set to "Configure".
The existing data is adopted.
–
Adoption of the data from STEP 7 V5 without the option of making changes
A physical V2.1 CP can be exchanged for a V3.1 CP but not the other way round. The
CP used must have hardware product version 2. The existing data is adopted.
Requirements: TIM 1531 IRC
●
Communication partner of the TIM 1531 IRC
Requirements for importing ST7 connections between a TIM 1531 IRC and a CPU 1500:
– The CPU 1500 must have at least the firmware version V2.5.
– TIM and CPU must be networked in STEP 7 Professional before the import.
– When using TD7onCPU, the CPU must not yet be assigned to the TIM in
STEP 7 Professional.
Requirements for ST7 connections between a TIM 1531 IRC and a PC application:
– Prior to import, the TIM and the PC station must be networked in
STEP 7 Professional.
IP addresses of a CPU 1500 or a PC station as ST7 communication partner of the
TIM 1531 IRC:
– The IP address in the STEP 7 Professional project must be identical to the address of
the respective CPU or PC station configured in STEP 7 V5.
To Next Page
Loading...
Need help?
General
