LEDs, connectors, switches, card slot
2.4 Switch
TIM 1531 IRC
36 Operating Instructions, 02/2018, C79000-G8976-C468-02
●
Maintenance status
The setting "MRES" is adopted by pressing and holding down the switch in this position
(button function).
By pressing the switch for at least 5 seconds, the functions described below are
triggered. If you release the switch before the 5 seconds have elapsed, the TIM shows no
reaction.
Functions:
– Restart
When the switch is pressed in STOP mode
The TIM restarts.
– Reset to factory settings
Only when the switch is pressed during a restart
The TIM is reset to the factory settings. Note the effects of the reset, particularly the
deletion of the configuration data.
For information on the effects of resetting, refer to the section Resetting to factory
settings (Page 287).
Functions in the setting "MRES"
Functions when holding the switch in the "MRES" setting for at least 5 seconds:
Table 2- 6 Button functions
Previous setting or action
Pressing the switch from the "STOP"
setting
The TIM restarts.
Release the switch at the beginning of
Pressing the switch after triggering a
restart
The TIM is reset to the factory set-
tings. All the configuration data is
deleted.
For the relevant LED patterns see the following section:
● Startup - LED pattern (Page 49)
● Resetting to factory settings (Page 287)
To Next Page
Loading...
