Simrad CA42 - 9.5 Data transfer via PC interface

CA42/50/52 Miscellaneous menu Chapter 9
129
9.5 Data transfer via PC interface
Data transfer to and from a route planning program on a Personal
Computer can be made via NMEA connection (Refer to Installation
manual section 11.8) by means of the standard NMEA0183 sentences
WPL and RTE.
) The data transfer on these two sentences does not include WP
symbol, color, XTE limit, etc.
MENU
Call up the menu bar, and…
7,4
load the Data transfer window
Data transfer
_1_
DataCard upper drawer
- see section 9.4
_3_ DataCard lower drawer
- see section 9.4
_7_
NMEA connection
_MENU_
Exit
7
Select the NMEA connection
WARNING!
Normal NMEA communication on
selected channel will be
interrupted.
_1_ NMEA 1
_3_ NMEA 2
_MENU_
Exit
Press [1] or [3] to select the NMEA port where the PC data cable is
connected. Example:
NMEA 1 connection
_1_
Transmit WPs
_3_
Transmit routes
_7_
Receive WPs and routes
_MENU_
Exit
The normal communication via this
NMEA port is temporarily abrupted
during the time of data transfer.