CA42/50/52 NAV menus & navigation examples Chapter 6
65
6.1 NAV menu – (NAV inactive)
_4_
NAV
_1_ Highway
- see section 6.1.1
_2_ Waypoint navigation
- see section 6.5.2
_3_ Route navigation
- see section 6.5.3
_4_ Track navigation
- see section 6.5.4
_5_ Anchor guard
- see section 6.3
_6_ Trim & highway
- see section 6.2.7
_7_ Set & drift
- see section 6.2.8
This NAV menu will appear when there is no navigation mode active.
See also section 6.2 –whennavigationmodeisactive,section6.3
Anchor guard, 6.4 MOB navigation, and 6.5 Navigation examples.
6.1.1 Highway display
MENU
Call up the menu bar, and…
4,1
load Highway display
Since there is no navigation mode active, you will receive the legend:
NAVIGATION IS OFF. To enter the basic Navigation setup display:
ENT
Press
[ENT]
to call up Navigation setup
- see display example next page.
Before starting out in one of the navigation modes, it may be a good
idea to check out the Navigation setup display and see if the default
settings will suit your need.
To Next Page
Loading...
Need help?
General
