CA42/50/52 Waypoint/route menus Chapter 5
58
5.4 Lines stored in the memory
The line list will keep a record of all the saved lines in the system.
It will provide information on number of line sections in line, etc.
“Lines” are used for defining a certain area on the chart, e.g. a fishing
ground, a shipwreck, large rocks, restricted areas, etc., or defining a
channel to sail through narrow passages, making your own coast line or
for whatever reason you could use a drawing on the chart.
) To draw new lines you need a chart in the active window, place the
cursor where you wish to start the line, and press
[PLOT].
Then follow
the instructions in the info windows. Refer to section 3.3.9.
Lines can also be edited directly on the chart via info windows. Refer
to section 3.3.4 and 3.3.5.
MENU
Call up the menu bar, and…
3,4
load line display
) Only plotted lines saved in the memory can be called forward.
Line: FISHING BORDER 0005
Line: ON
1: 56°52.700N 009°50.230E
2: 56°52.712N 009°50.431E
3: 56°52.723N 009°50.654E
4: 56°52.756N 009°50.760E
5: 56°52.856N 009°50.899E
6: 56°52.901N 009°51.232E
7: 56°53.230N 009°51.400E
8: 56°53.650N 009°51.432E
9: 56°53.897N 009°51.230E
10: 56°54.220N 009°52.110E
Number of sections in line: 16
This display
indicates
how many
line sections
are used for
the drawing.
+/-
Toggle through the stored lines with the +/- keys, or…
Leaf through the line points by moving cursor up/down
To Next Page
Loading...
Need help?
General
