CA42/50/52 Position menus Chapter 4
45
4.6 DGPS information
The DGPS – differential position corrections – canbeprovidedfroma
built-in module, which is preset to full automatic operation, or from
connected DGPS receiver – see ‘Status indicator’ in position display.
) List of beacon stations is available in addendum, part no.
183.0122.501.
MENU
Call up the menu bar, and…
2,6
load DGPS setup display (with built-in module)
DGPS setup:
Beacon: SKAGEN B312° D87.3nm
Status: LOCKED
Beacon is monitored: YES
Frequency: 298.5kHz MANUAL
Bit rate: 100bps AUTO
Signal strength: 17
Signal to noise ratio (SNR): 23dB
Message:
To receive
valid diffe-
rential data
will require
that the
navigator is
locked in on
abeacon
station.
ENT
Open for change, and…
Go to the function you wish to alter
+/-
Toggle the function, or…
0-9
insert new figures
ENT
Confirm entry
Beacon – informs the name of the beacon the navigator is locked on to
(if any), together with indication of bearing and distance.
To Next Page
Loading...
