Simrad CA42 - 3.3.6 Cursor placed on trackpoint

CA42/50/52 Chart menus and INFO windows Chapter 3
27
3.3.6 Cursor placed on trackpoint
Trackpoints are not as easily recognized as Routepoints, you may have
to move the cursor along on the track to locate a trackpoint.
ENT
With chart in active display and cursor placed on a trackpoint, press
[ENT]
to call up an info window with the following to choose from:
Trackpoint found: 3
Name: TRACK 1
Total: 836 points – 83.6nm
-Example.
1
Edit user data
2
Chart info
-Refer to Appendix C.
3
Find nearest port services
-Refer to Appendix C.
4
Bearing & dist. from A to B
-Refer to section 3.3.2.
5
Lock cursors
-Refer to section 3.3.2.
9
Chart setup
-Refer to section 3.4.
0
Cursor to center
-Refer to section 3.3.2.
GOTO
Select NAV mode
-Refer to section 3.3.8.
PLOT
Plot new data
-Refer to section 3.3.9.
PAGE
More user data
MENU
Exit
-Exit info window.
1
Edit user data opens for a new info window:
Trackpoint
CLR
Delete point
Delete trackpoint ? “YES” / ”NO”
1
Delete points from A to B
*) see below.
2
Edit
New info window to edit track.
3
Delete
Delete whole track ?
“YES”/”NO”
MENU
Exit
Exit info window.
*) Move cursor to point B and press [ENT] to delete all trackpoints
between cursor position on chart and point B.