CA42/50/52 Position menus Chapter 4
40
4.3 Speed, course & depth
MENU
Call up the menu bar, and…
2,3
load Speed, course & depth display
Speed over ground
*.*kn
Course
*m
Depth below keel
*.*m
This display is
preset to show:
Speed over ground
in knots,
Magnetic course
and Depth below
keel in meters.
To change the settings for this display:
• Speed over ground can be changed from the Position display settings
to show Speed through water: Press [MENU], [2], [1], [ENT], go to the
line “Display speed as: SOG”, press the [+] key to toggle to STW,
press [ENT] to accept the change. The top line in above display will
now show Speed through water.
• Course can be shown as magnetic or true. Toggle between the two
settings from the Position display: Press [MENU], [2], [1], [ENT], go
to the line “Course and bearing as: MAGNETIC”,pressthe[+]keyto
toggle to TRUE, press [ENT] to accept the change. The middle part in
above display will now show True course e.g. 17°.
• Depth below keel can be changed from the Echosounder setup to
show Depth below surface or Depth below transducer. Press [MENU],
[5], [8], go to the line “Display: DEPTH BELOW KEEL”,pressthe
[+] key to toggle to DEPTH BELOW SURFACE or DEPTH BELOW
TRANSDUCER, press [ENT] to accept the change. The new setting
will be shown in the lower part of the display.
To Next Page
Loading...
