CA42/50/52 Waypoint/route menus Chapter 5
63
5.7 Targets stored in the memory
The CAXX can display the bearing and distance of up to three targets
at a time in relation to the vessel e.g. harbors or important navigational
points. A target is a fixed point on the chart which can be plotted by the
cursor or from the ship’s position, or keyed in via the keypad.
Set up targets
The plotted target position is automatically preset to actual position of
ship, or to cursor position when the chart display is active and the
cursor is on – see INFO windows, section 3.3.7.
MENU
Call up the menu bar, and…
3,8
load target display
Targets:
Name: TARGET 1 ON
Position: 56°52.700N 9°50.500E
B 213° D 195.7nm
Name: TARGET 2 ON
Position: 54°51.500N 9°52.135E
B 130° D 215.7nm
Name: TARGET 3 ON
Make the
target
invisible on
the screen by
turning it
OFF.
Putitback
on the screen
by turning it
ON again.
Position: 56°52.700N 9°50.500E
B 345° D 295.7nm
Select the target you wish to change or replace with a different target
by moving the cursor up/down
+/-
Leaf through the targets in the memory
ENT
Open for change, and…
Place cursor where you wish to make a change i.e. name, color, etc.
To Next Page
Loading...
Need help?
General
