EasyManuals Logo

Skyjack SJ12 E Service Manual

Skyjack SJ12 E
170 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16
SJ12 E, SJ16 E, SJ20 E
241914ACA
Section 2 – Scheduled Maintenance Visual and daily maintenance inspections
1.7-5 Base
Do the inspection that follows:
1
Base weldment, B
There are no cracks in the welds or the
structure.
There are no signs of deformation
2
Display Panel, B
Make sure the panel is correctly attached and
there is no damage.
3
Battery charger, B
Make sure the battery charger is correctly
installed, and in good condition.
Make sure there is no visible damage.
4
Pothole protection, B
Make sure there are no visible cracks or signs
of damage or deformation.
5
Steer cylinder, B
Make sure the steer cylinder is correctly
installed.
Make sure there are no loose or missing
fasteners.
Make sure there is no visible damage.
1.7-6 Wheel/tire assembly
A small amount of wear is permitted. But if any of the
wear or damage meets the criteria mentioned below,
the tire should be replaced.
WARNING
Do not use tires other than the tires that Skyjack
species for this MEWP. Do not mix different types
of tires or use tires that are not in good condition.
Only replace the tires with the same types that are
approved by Skyjack. The use of other tires can
make the MEWP less stable. If you do not obey,
there is a risk of death or serious injury.
6
8 9
1
4 7
3
2
5

Table of Contents

Other manuals for Skyjack SJ12 E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Skyjack SJ12 E and is the answer not in the manual?

Skyjack SJ12 E Specifications

General IconGeneral
BrandSkyjack
ModelSJ12 E
CategoryLifting Systems
LanguageEnglish

Related product manuals