Skyjack SJ12 E - Platform Assembly

18
SJ12 E, SJ16 E, SJ20 E
241914ACA
Section 2 – Scheduled Maintenance Visual and daily maintenance inspections
1.7-7 Platform assembly
Do the inspection that follows:
WARNING
Fall hazard. Use the three points of contact
principle when you use the MEWP to enter or exit
the platform. If you do not obey, there is a risk of
death or serious injury.
1. Enter the platform and close the gate.
1
Platform, B
▪
Make sure there are no loose or missing parts,
and there is no visible damage.
▪
Make sure all railings are correctly installed.
▪
Make sure all fasteners are tight.
▪
Make sure the gate is in good condition and
operates correctly.
▪
Make sure the platform foot pedal is in good
working order, it has no loose or missing parts,
and there is no visible damage.
2
Fall-protection anchorages, B
▪
Make sure the fall-protection anchorages are
correctly attached.
▪
Make sure the fall protection anchorages show
no signs of visible damage, deformation, or
cracks.
3
AC power socket, B
▪
Make sure the socket is free of dirt or
blockages.
4
Platform control console, B
▪
Make sure the control console is locked with
the lock pin.
▪
Make sure the platform control cable is
correctly locked, and there is no visible
damage.
2. Exit the platform, and close the gate.
5
Manual storage box, B
▪
Make sure the operation manual and other
important documents are in the manual
storage box.
▪
Make sure the documents are in good
condition, and you can read them.
1
4
3
5
2