Chapter 4 Connecting computers and other devices
docs.smarttech.com/kb/171904 104
Sharing USB Type-B receptacles
The HDMI, VGA, and Display Port connectors on the rear connector panels (back of the display) all share
a single USB Type-B receptacle on the rear, side panel. This means the touch system can be used with
only one device connected to these video inputs.
The touch system can still be used with a device connected to USB Type-B receptacle even when one of
the video connectors is connected to another display.
USB Type-B receptacle Video connectors
Touch
l
HDMI 1
l
HDMI 2
l
VGA
l
Display Port
Connecting a SMART OPS PC module
If your organization has purchased a SMART OPS PC module, you or your
organization’s installers can install the module in the display’s accessory slot
following the OPS PC module’s installation instructions
(docs.smarttech.com/kb/171775 or docs.smarttech.com/kb/171544). You can
then view the OPS PC module’s input on the display.
See
SMART OPS PC modules user guide
(docs.smarttech.com/kb/171747)
To Next Page
Loading...
Need help?
General
