docs.smarttech.com/kb/171904 107
Certification and compliance
Note
For the purposes of certification, the SMART Board GX (V3)
series of displays are identified as models IDGX65-2,
IDGX75-2, and IDGX86-2.
Accessing the display’s e-label
information
An electronic (e-label) version of the GX (V3) display’s
regulatory information is available in the display’s settings.
From the Home screen, tap the Apps icon Settings icon
Regulatory Information.
For more information, see the
SMART Board GX (V3) series
interactive displays user guide
(docs.smarttech.com/kb/171903
Federal Communication Commission
interference statement
FCC
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier: IDGX65-2, IDGX75-2, IDGX86-2
Responsible Party – U.S. Contact Information
SMART Technologies Inc.
2401 4th Ave, 3rd Floor
Seattle, WA 98121
compliance@smarttech.com
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
Note
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required
to correct the interference at his own expense.
Caution
Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate this equipment.
Restriction
Operations in the 5.15-5.25 GHz band are restricted to indoor
usage only.
IEEE 802.11b or 802.11g operation of this product in the USA is
firmware limited to channels 1 through 11.
Radiation exposure statement
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance of 20 cm
between the antenna of this device and all nearby persons.
This transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
Innovation, Science and Economic
Development Canada statement
This device complies with RSS-210 of the Innovation, Science
and Economic Development Canada Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
To Next Page
Loading...
Need help?
General
