I2773-4.4 en
43
Somat eDAQ
lite
For more information on setting up an input channel, see “Creating Channels and
DataModes™” on page 61. For information on specific input channel types, see “Input
Channels” on page 107.
Computed Channel Setup
Use the computed channel window to define any computed channels required for the
test. A computed channel is derived from one or more transducer or previously defined
computed channels. Defining computed channels in a test setup is optional.
NOTE
A computed channel referencing a previously defined computed channel must be
listed below the referenced channel in the setup window.
Option Description
Add Add a new transducer definition to the setup. TCE adds the new
transducer above the selected entry.
Del Delete the selected transducer channels.
Edit Modify the selected transducer channel definitions. Edit a single
transducer definition or a group of transducers of the same channel
type.
Copy Copy the selected transducer definition into one or more new
transducer definitions. TCE adds the new transducers below the
selected entry.
Sort Sort the transducer channels list alphabetically by connector ID.
DVM Run a DVM display for the selected transducer channels. This option
is not available when a test is initialized. For more information on the
DVM display, see “DVM” on page 75.
Scope Run the scope display for the selected transducer channel. The scope
display is limited to a single channel. This option is not available when
a test is initialized. For more information on the scope display, see
“Scope Plot” on page 77.
Freq Run the spectrum analyzer display for the selected transducer
channel. The spectrum display is limited to a single channel. This
option is not available when a test is initialized. For more information
on the spectrum display, see “Spectrum Plot” on page 78.
Cal Perform various calibration tasks on the selected transducer channels.
This option is not available when a test is initialized. For more
information on calibrating channels, see “Calibrating Input Channels”
on page 63.
Ampl Report the selected signal conditioner amplifier settings. This option is
provided primarily for HBM development.
SMART Utils Open the SMART module utilities window. This option is applicable for
a SMART module transducer channel. For more information on
SMART utilities, see “Using SMART Utilities” on page 118.
HBM: public
To Next Page
Loading...