Sonic KSE-310 - Page 125

To Next Page

To Previous Page

II-115

Fig. 2-108 Screen structure setting procedure

Note: The fish length graph, TS graph, and trace graph are valid only at

frequencies of 38, 70, and 120 kHz.

Main Page

Table of Contents5
Introduction9
Operation Overview11
Explanation of the Controller11
Explanation of the Screens12
Power on and off13
Power on13
Power off13
Adjust Gain14
RANGE and SHIFT + Manual/Auto15
Displaying EXPANSION SCREEN17
Expansion Screen Display19
Expansion Screen Structure21
Displaying a SCOPE23
Displaying BOTTOM LINE25
How to Use Cursors28
H Cursor29
Cursor30
Use of FISH LENGTH GRAPH and TS GRAPH32
How to Select Fish Schools34
How to Make the Graph more Visible42
Splitting the Fish Length Detection Range46
TS GRAPH Setting48
How to Use TRACE GRAPH49
How to Display TRACE GRAPH49
Trace Graph Display Area51
TRACE GRAPH Setting53
Biomass Display54
Method of Estimating the Biomass54
How to Use Biomass Display56
How to Use COLOR PATTERN60
How to Make the es Image Easy to See62
Changing the Display Color (Color Pattern62
How to Use the Color Clutter64
How to Use INTERFERENCE REJECTION65
How to Use MEMORY/REPLAY67
Replay Setting67
Memory Setting68
How to Use REPLAY PICTURE69
Items of REPLAY PICTURE70
Setting AUTO-RECORD SETTING73
How to Use Auto-Record74
How to Set Saving76
How to Check the Available Recording Hour / Recording Size77
Calibration79
Calibration Setting Screen80
Calibration Parameter Setting Screen82
Screen Structure at the Start of the Calibration83
CALIBRATION CONTROL Window84
Calibration Ball Trace Graph86
TR Graph Window87
TR Graph Setting Screen88
Cursor Control Window and Depth Window for the Calibration89
Calibration Work91
The User Key99
How to Set the User Key99
How to Use the User Key101
Multi-Frequency Function103
Screen Structure When Using One Display Unit103
Screen Structure When Using Two Display Units111
Freq Diff126
Assignment129
Explanation of the Menu130
Main Menu130
Memory/Replay131
Display131
Setting139
System151
Tool155
Help157
Shortcut Menu160
Screen Setting161
Sea Bottom Hardness162
Olex162
Tx Setting167
Rx Setting168
Signal Process Setting170
Color Pattern Setting172
Interface173
J30 Connector Pin Assignment173
How to Use EXTERNAL SYNC174
Connection of the EXTERNAL SYNC Signal174
EXTERNAL SYNC Signal Standard174
Menu Setting176
EXTERNAL TRIGGER OUTPUT Setting178
Connection of EXTERNAL TRIGGER OUTPUT Signal178
EXTERNAL TRIGGER OUTPUT Signal Standard179
Types and Settings of the EXTERNAL TRIGGER OUTPUT Signals180
Net Depth Gauge Input Setting182
KNF(NMEA2) Input182
Net Depth Input183
NMEA Input Setting187
NMEA Input187
NMEA Output188
Assigning J51 Connector Pins191
Signal Output Setting191
Connecting the es Trigger Output Signals192
Standard for es Trigger Output Signals192
Connecting the es Output Signals193
Installation194
CB25 Bridge to Tx/Rx194
Transducer Connection194
Troubleshooting195
Network195
Hardware Problems: Examples and Measures197
Error Message199
Alert Messages200

Sonic KSE-310 - Page 125

Table of Contents

Related product manuals