II-117
(1) FREQUENCY1 (BASIC)
This is for selecting the basics of ES to be used for obtaining the difference.
(Frequencies for the ES number (1 to 4) can be selected according to “ES
ASSIGNMENT" described in Section 2-18-4.)
(2) FREQUENCY2
This is for selecting an ES to be used for obtaining the difference from
FREQUENCY1.
(ES selected for FREQUENCY1 becomes inactive and cannot be selected.)
(3) MIN DIFFERENCE THRESHOLD
For setting the minimum difference threshold.
(From -99 to 99 can be selected)*
(4) MAX DIFFERENCE THRESHOLD
For setting the maximum difference threshold.
(From -99 to 99 can be selected)*
*When the minimum value higher than the maximum value is set, the message
shown.
(The same applies to the case where the maximum value less than the minimum
value is set.)
(5) DISCRIMINATION HORIZONTAL
This is for the discrimination processing in the horizontal direction to be formed
before obtaining the difference.
(1 to 20 can be selected)
(6) DISCRIMINATION VERTICAL
This is for the discrimination processing in the vertical direction to be formed before
obtaining the difference.
(1 to 20 can be selected)
To Next Page
Loading...