Sonic KSE-310 - Page 149

III-139
FREQ.DIFF.SETTING
This is described in Section 2-18-3.
COEFFICIENT SETTING
COEFFICIENT SETTING is for displaying the parameter file of the frequency
installed.
Fig. 3-27 shows the screen when the frequency is 38KHz split beam
Table 3-7 Descriptions of frequency parameter items
No.
Item
Setting
Rage
Step
Range
Default
1
FREQ PARAMETER FILE
-
-
(*)_Default_FreqParam.xml
2
ABSORBED
ATTENUATION
0-99.9
0.1
(it depends on the frequency of the
transducer installed.)
3
SINGLE WAVEFORM
DETECTION JUDGMENT
FILE (0.3ms,0.6ms,1.2ms
and 2.4ms)
-
-
(*)_Default_FishLength_03ms.xml
(*)_Default_FishLength_06ms.xml
(*)_Default_FishLength_12ms.xml
(*)_Default_FishLength_24ms.xml
4
SEA BOTTOM
PARAMETER FILE
-
-
(*)_Default_BottomParam.xml
Depending on the frequency, (*) will be as follows:
A single beam type of 15kHz:f15kHz A single beam type of 24kHz:f24kHz
A sprit beam type of 38 kHz: f38kHz_SP A single beam type of 50kHz: f24kHz
A sprit beam type of 70kHz: f70kHz_SP A single beam type of 75kHz: f75kHz
A sprit beam type of 120kHz: f120kHz_SP A single beam type of 200kHz: f200kHz
(1)
(2)
(4)
(3)
5
6