Step 1 Preparing the power supply
(1) Lift up tile viewfinder.
(2) Slide tile battery pack down until it clicks.
To remove the battery pack
(1) Liftup tile viewfinder.
(2) Slidetile battery pack out in the direction of ttle arrow while pressing BATT
(battery) release lever down.
(battery)
release lever
If you install the large-capacity battery pack
If you install tile NP FMT0/QMT1/FM90/QM91/FM91 battery pack on your
camcorder, extend its viewfinder.
12
To Next Page
Loading...
