Superimposing a still image in the" Memory Stick" on an image
- MEMORY MIX
Before operation
Insert a" Memory Stick" is recorded still images into your camcorder.
(1) Set the POWER switch to MEMORY. Make sure that tile LOCK switch is set to
tile left (unlock) position.
(2) Press MEMORY MIX.
Tile last recorded or last composed image appears on the lower part of the
screen as a thumbnail image.
(3) Press MEMORY+/ to select the still image you want to superimpose.
To see the previous image, press MEMORY . To see the next image, press
MEMORY+.
(4) Turn the SEL/PUSH EXEC dial to select the desired mode.
The mode changes as follows:
M. CHROM *-_ M. LUMI *-+ C. CHROM
(5) Press the SEL/PUSH EXEC dial.
Tile still image is superimposed on the moving picture.
(6) Turn the SEL/PUSH EXEC dial to adjust the effect.
M. CHROM Tile color (blue) scheme of tile area in tile still image which is
to be swapped with a moving picture
M. LUMI The color (brigh0 scheme of the area in tile still image which
is to be swapped with a moving picture
C. CHROM The color (blue) scheme of the area in the moving picture
which is to be swapped with a still image
The fewer bars there are on tile screen, the stronger the effect becomes.
(7) Press PHOTO deeper to start recording.
Tile image displayed on tile screen will be recorded on a _Memory Stick."
Recording is complete when the bar scroll indicator disappears.
132
To Next Page
Loading...
