Dubbing only desired scenes - Digital program editing (on tapes)
(2) Setting the modes to cancel the recording pause on the VCR
(3) Turn the SEL/PUSH EXEC dial to select PAUSEMODE, then press tile dial.
@ Turn the SEL/PUSH EXEC dial to select the mode to cancel recording pause
on the VCR, then press the dial.
Refer to tile operating instructions of your VCR.
Buttons to cancel recording pause on the VCR
The butlons vary depending on your VCR. To cancel recording pause:
Select PAUSE if the button to cancel recording pause is | |.
Select REC if the button to cancel recording pause is 0.
Select PB if the button to cancel recording pause is Im,_.
(3) Setting your camcorder and the VCR to face each other
Locate the infrared rays emitter of your camcorder and face it towards the remote
sensor of the VCR.
Set the devices about 30 cm (12 in.) apart, and remove any obstacles between the
devices.
VCR
Remote sensor
A/V connecting cable {supplied)
78
To Next Page
Loading...
