Dubbing only desired scenes - Digital program editing (on tapes)
You can adjust the synchronization of your camcorder and the VCR. Have a pen and
paper ready for notes. Before operation, eject the cassette from your camcorder if
inserted.
(1) Set the POWER switch to VCR on your camcorder.
(2) Insert a blank tape (or a tape you want to record over) into the VCR, then set
to recording pause.
When you select i.LINK in CONTROL, you do not need to set to recording
pause.
(3) Turn the SEL/PUSH EXEC dial to select ADJ TEST, then press tile dial.
(4) Turn the SEL/PUSH EXEC dial to select EXECUTE, then press the dial.
IN and OUT are recorded on an image for five times each to calculate the
number values for adjusting the synchronization.
Tile EXECUTING indicator flashes on tile screen.
When finished, tile indicator changes to COMPLETE,
(5) Rewind the tape in tile VCR, then start slow playback.
Take a note of the first number value of each IN and tile last number value of
each OUT.
(6) Calculate the average of all the first number values of each IN, and the
average of all tile last number values of each OUT.
(7) Turn the SEL/PUSH EXEC dial to select _ CUTqN", then press the dial.
(8) Turn the SEL/PUSH EXEC dial to select the average number value of IN, then
press the dial.
The calculated start position for recording is set.
(9) Turn the SEL/PUSH EXEC dial to select _ CUT-OUT', then press the dial.
(10) Turn the SEL/PUSH EXEC dial to select the average number value of OUT,
then press the dial.
The calculated stop position for recording is set.
(11)Turn the SEL/PUSH EXEC dial to select aia RETURN, then press the dial.
82
To Next Page
Loading...
