Sony Digital 8 DCR-TRV340 - Page 84

Dubbing only desired scenes - Digital program editing (on tapes)
(1) Insert tile tape for playback into your camcorder, and insert a tape for
recording into the VCR.
(2) Press MENU to display tile menu settings.
(3) Turn the SEL/PUSH EXEC dial to select _m_,then press tile dial.
(4) For DCR-TRV240:
Turn the SEL/PUSH EXEC dial to select VIDEO EDIT, then press tile dial.
For DCR-TRV340/TRV?40/TRV840:
Turn the SEL/PUSH EXEC dial to select TAPE in VIDEO EDIT, then press tile
dial.
(5) Search for tile beginning of the first scene you want to insert using tile video
operation buttons, then pause playback.
You can fine-adjust one frame at a time with EDITSEARCH.
(6) Press the SEL/PUSH EXEC dial.
The IN poim of the first program is set, and tile top part of the program mark
changes to light blue.
(7) Search for tile end of the first scene you want to insert using tile video
operation buttons, then pause playback.
(8) Press the SEL/PUSH EXEC dial.
Tile OUT point of the first program is set, then the bottom part of the program
mark changes to light blue.
(9) Repeat steps 5 to 8, then set tile program.
When the program is set, tile program mark changes to light blue.
You can set up to 20 programs.
84