Speco N8NXP - Upnp (EZ Network)

73
4.10.1.5 UPnP (EZ Network)
UPnP is used to establish necessary connections between the device and the router to provide access to the
internet. Please make sure that the default gateway is set under the TCP/IP section. See Figure 4-67 for the
UPnP interface.
 Enable: Check to enable UPnP.
 Status: Displays the UPnP connection status.
 LAN: Value of the default gateway.
 WAN: Public IP address of the router.
 Port Mapping List
 Service name：Default list. More can be defined by the user.
 Protocol： Protocol type
 Internal port：Port that has been mapped in the router.
 External port：Port that has been mapped locally.
 Default: Press Default and then Apply to restore the default list.
 Add: Used to add new items to the list
 Delete: Used to remove items from the list. Make sure the checkbox for the item is selected first.
Double click an item to view or change the mapping information. See Figure 4-68.
Important:
When setting the external port, please use a port in the range 1024~5000. Do not use ports 1~1023 to
avoid conflicts.
For TCP and UDP, please make sure the internal port and external port are the same to guarantee
proper data transmission.