STEP AS380 Series User Manual

Shanghai STEP Electric Corporation
Chapter 6 Introduction to the supporting products
126
Table 6.16 A SM-04-VL16/A plug-in specification and port definition
Serial
Descriptions
Remarks
JP1
Serial port, of which Pin 1 for TXV+, Pin 2 for TXV-, Pin 3 for TXA+ and
Pin 4 for TXA- respectively.
CH3.96-4
JP2
Up-call terminals, of which Pin 1- and Pin 2+ for button indicator, Pin 3 and
Pin 4 for button input.
CH2510-4
JP3
Down-call terminals, of which Pin 1- and Pin 2+ for button indicator, Pin 3
and Pin 4 for button input.
CH2510-4
JP4
Pin 3 and Pin 4 of JP5 connected to the normal open contact of elevator –lock
switch
CH2510-4
JP5
Pin 3 and Pin 4 of JP6 is the port for passenger button
CH2510-4
SW2
The dip switch of serial communication terminal resistor , right turn mean the
connection of built-in 120Ω resistor
SW1.2
SW1.2 ON for display in English, OFF for display in Chinese and English
together.
SW1.3
SW1.3 ON for 64 floor mode, otherwise, for 48 floor mode.
SW1.4
SW1.4 ON for setting address codes of the display board, and SW1.4 OFF
after setting finished.
6.5.6 In-car SM-04-VL/B3 outside view and installation
dimension

STEP AS380 Series Specifications

General

Brand	STEP
Model	AS380 Series
Category	Controller
Language	English