Instruction Manual for AS380 Series Elevator Integrated Drive Controller
Chapter 6 Introduction to the supporting products
The definitions and display symbols of the terminals may vary with the edition. The above
listing is the one based on the standard edition.
◌ Wiring and Connection
1. The connection of the display Board for power supply and communication is shown in Fig.
6.32, the power supply and communication is made available via a 4-pin plug, of which Pin 1
for TXV+, Pin 2 for TXV-, both with DC24V power supply; Pin3 for TXA+ and Pin 4 for
TXA- are communication lines. The lines for communication must be Twisted Pairs.
2 The connection between the display Board and the landing push button is shown in Fig. 6.31.
i.e., Pin 1 and Pin 2 for push-button indicator lamp, whereas Pin 3 and Pin 4 for the push button.
Fig. 6.31 Connection of the Push Button Fig. 6.32 Connection of Communication
Lines
6.6 SM.GC/C board introduction
6.6.1 System Structure
Each group control system must need only a group control cabinet, whose core part is the
group control board SM-GC/C. SM-GC/C communicates with each elevator control cabinet
SM-01 in group control system through CAN-BUS, and deploys the elevators into efficiently
group control running status. System structure is shown as below:
To Next Page
Loading...
Need help?
General
