Instruction Manual for AS380 Series Elevator Integrated Drive Controller
Chapter 2 Model And Specification
2.4 Installation instructions
◉ Always install on metal structures or other noninflammable objects;
Or it may cause fire risk.
◉ Never place combustibles near the product
Or it may cause fire risk.
◉ Never install in explosive environments
Or it may cause explosion risk
◉ The cabinet in which the product will be installed shall meet the
requirements of EN50178.
◉ The platform on which the product will be installed shall have
sufficient load bearing capacity
Or the contingent falling of the main body of elevator integrated drive
controller may case risk of injury and/or property damage
◉ Don’t install it in the vicinity of sewage pipe or the points with
splatters
Or it may cause risk of property damage.
◉ Prevent screws, washers and metal rods falling into the inside of
elevator integrated drive controller
Or it may cause the risk of fire or property damage.
◉ Never start a elevator integrated drive controller which is damaged
or components are not completed mounted
Or it may cause risk of property damage.
◉ Don’t install under direct sunlight
Or it may cause risk of overheat or resulting accidents;
2.4.1 Product installation location
The place where the elevator integrated drive controller will be installed shall meet such
conditions as:
a) Clean, without oil mist, dust or suspended matters which may fly into the fully enclosed
cabinet；
b) No possibility of metal powder, oil or water entering into the inside of elevator integrated
drive controller;
c) No timers and other combustibles are stored;
To Next Page
Loading...
Need help?
General
