Instruction Manual for AS380 Series Elevator Integrated Drive Controller
VII
6.6.8 Connection Method of Group Control System __________________________________ 147
6.6.9 Setting of Group Control Operation __________________________________________ 147
6.6.10 Instruction of group control program to setup parameters ________________________ 148
Chapter 7 Parameter Table of Integrated Drive Controller ..................................... 163
7.1 F Parameter List ........................................................................................................ 163
7.2 Definition of function parameter .............................................................................. 172
Chapter 8 Elevator Elevator Commissioning Guide ................................................ 195
8.2 Check before Power on .............................................................................................. 198
8.3 Power on and Check .................................................................................................. 198
8.3.1 Confirmation before Power on ______________________________________________ 198
8.3.2 Checks after Power on ____________________________________________________ 199
Configuration of System Basic Parameters and Self Study of Motor Parameters .... 199
8.4.1 Configuration of System Basic Parameters ____________________________________ 199
8.4.2 Motor Parameter Self Study ________________________________________________ 201
8.5 Test Run of Slow Car ................................................................................................. 202
8.5.1 Inspection Operation of Engine Room and Preparations for Express Car _____________ 202
8.5.2 Car Top Inspection Operation ______________________________________________ 203
8.5.3 Check of CAN Communication Lines and Setting of 04 Board Address ______________ 204
8.5.4 Door Opening/Closing Adjustment __________________________________________ 205
8.6 hoist way Self Study ................................................................................................... 205
8.6.1 Hoistway Self Study Method _______________________________________________ 205
8.7 Express Car Operation .............................................................................................. 206
8.8 Adjust Elevator Comfort ........................................................................................... 210
8.8.1 Factors Relating to Elevator Comfort in Operation ______________________________ 210
8.8.2 Adjust Elevator Comfort __________________________________________________ 210
8.9 Leveling Adjustment .................................................................................................. 218
8.10 Method for Adjusting Pre-Load Weighing Compensation at Elevator Start ..... 224
8.10.1 Use of DTZZ-III-DC-SC _________________________________________________ 226
8.10.2 Use of non-DTZZ-III-DC-SC weighing device (F164 set to 1, 2, 5 or 6) to compensate or
adjust the start _______________________________________________________________ 227
8.10.3 Simple compensation by using light-load and heavy-load switch (F164 set to 4) ______ 228
8.11 The adjustment of other function ........................................................................... 229
Chapter 9 Faults and Solutions ................................................................................ 231
9.1 The fault analysis of the integrated device control system ..................................... 231
9.2 fault analysis of Integrated drive system ................................................................. 237
Chapter 10 Maintenance........................................................................................... 243
10.1 Warranty .................................................................................................................. 243
To Next Page
Loading...
Need help?
General
