Steris V-PRO maX 2 - Memory Write Error - ALM; No Power - Nonalm; Odor or Oil Misting from Unit - Nonalm; Oil Leak - Nonalm

7 — Troubleshooting
66
Operator Manual
V-PRO
®
maX 2
10085896_H
7.42 Memory Write Error — ALM
Condition
Occurs if there is an error writing data to non-volatile memory.
General Troubleshooting
Additional Information
Acknowledge alarm.
1. Cycle power on Unit.
2. Contact STERIS if alarm does not clear.
3. Load must be repackaged and reprocessed after
Abort Phase is completed.
7.43 No Power — NonALM
Condition
Screen blank and no power to Unit.
General Troubleshooting
Additional Information
Unit power off.
1. Verify facility power.
2. Turn Unit power ON.
3. If Unit still has no power, contact STERIS.
7.44 Odor or Oil Misting from Unit — NonALM
Condition
Odor caused by oil mist coming from vacuum pump oil exhaust filter (Non-Alarm).
General Troubleshooting
Additional Information
Contact STERIS.
1. Contact STERIS.
7.45 Oil Leak — NonALM
Condition
Oil dripping onto floor from Unit (Non-Alarm).
General Troubleshooting Additional Information
Contact STERIS.
1. Contact STERIS.