Stihl MS 441 - Page 118

117MS 441, MS 441 C
: Press grommet (1) into holes
(arrows) until rubber lips enclose
holes completely.
219RA521 TG
1
: Pull impulse hose (1) off
connector (arrow).
219RA101 TG
1
: Take out screws (arrows).
– Disconnect ground wire.
219RA522 TG
– Lift carburetor housing (1) and
turn it aside.
: Pull fuel hose (2) off elbow
connector (arrow).
: Pull out throttle cable (3).
219RA523 TG
2
3
1
– Pull out wiring harness on
machines with handle heating,
b 15.8.
– Remove and examine carburetor
housing, replace if necessary.
If a new housing is installed, all
attached parts must be transferred
to the new housing.
– Remove impulse hose,
b 14.6.4.
– Remove fuel hose,
b 14.8.2.
– Remove grommet /ignition cable
retainer, b 8.4.
: Take out screw (arrow).
– Pull out slide (1).
219RA528 TG
1
: Push slide (1) fully home in the
guide (arrow).
– Fit and tighten screw.
219RA524 TG
1
– Ease out grommet (1) and
examine it, replace if necessary.
– Use STIHL Press Fluid for easier
insertion, b 17.
219RA525 TG
1