118 MS 441, MS 441 C
: Press grommet in until rubber lip
completely encloses the oblong
hole.
– Install impulse hose,
b 14.6.4.
– Install fuel hose,
b 14.8.2.
– Install grommet/ ignition cable
retainer, b 8.4.
– Fit carburetor housing (1) and
turn it aside.
: Push fuel hose (2) onto elbow
connector (3).
: Push throttle cable (4) through
grommet (arrow).
219RA526 TG
2
3
1
4
– Install wiring harness in
machines with handle heating,
b 15.8.2.
Machines with QuickStop Super
– Guide fuel hose (1) under brake
cable (2) and push it onto the
elbow connector (arrow).
219RA096 TG
1
2
– Fit carburetor housing.
: Push impulse hose (1) onto
connector (arrow).
– Install ground wire, b 9.6.3.
219RA114 TG
1
– Install intake elbow,
b 14.6.3.
: Check that intake elbow is
correctly seated and tighten all
four screws (arrows) securely.
– Throttle cable must be routed
219RA522 TG
between impulse hose and fuel
hose.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5.
To Next Page
Loading...
