Stihl MS 441

29MS 441, MS 441 C
: Slightly lift up bearing eye of hand
guard and brake lever and guide
the parts over the pivot pins
(arrows).
219RA075 TG
: Turn cam lever (1) aside until
cam of hand guard (arrow) slides
past.
– Press bearing eye of the hand
guard and brake lever onto the
pivot pins.
219RA076 TG
1
: Attach brake spring (1) to brake
lever (arrow) and anchor pin (2).
219RA077 TG
1
2
: The turns of the brake spring
must be tightly spaced when not
installed; use a new brake spring
if necessary.
Check correct position of protective
tube: it must be centred on the
spring.
2
19RA078 TG
a = 20 mm
The pin for the brake spring must be
replaced if it shows signs of wear at
the groove, b 7.5.
: Hook brake spring (1) into brake
lever (arrow).
219RA165 TG
1
: Use assembly tool (2)
1117 890 0900 to attach brake
spring (1) to anchor pin (arrow).
– Adjust brake cable, b 7.3.1.
– Reassemble all other parts in the
reverse sequence.
219RA079 TG
1
2
– Tightening torques, b 3.5.
– Grease brake lever, b 17.