1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-72
Port Settings
Clicking the PORT SETTINGS tab brings up the VLAN PORT SETTINGS page (Figure 5-56),
which is used to associate the VLAN ID to the port for Port based VLAN classification.
MAC Based on All
Ports
This parameter enables or disables the per Port MAC based classification.
Port and Protocol
Based on all Ports
This parameter enables or disables the per Port Protocol based classification.
The user can enable/disable per-port protocol based Classification. In addition,
the Basic Settings page provides the configuration of Bridge Mode (Customer/
Provider) and Priority for tunneled STP BPDUs. When the user configures
Bridge Mode to Provider, the Port Protocol based classification and MAC-based
classification on all ports must be disabled.
Dynamic VLAN Oper
Status
Use this setting to enable/disable VLAN operational status.
Dynamic Multicast
Oper Status
Use this setting to enable/disable multicast operational status.
Maximum VLAN ID
This parameter specifies the largest (4069) valid VLAN ID, which this switch can
accept, above which all will be discarded.
Maximum Supported
VLANs
This parameter specifies the maximum number of VLANs that this device can
scale.
Number of VLANs in
the System
This parameter specifies the active number of VLANs configured in the device.
Figure 5-56. VLAN Port Settings Page
Table 5-44. VLAN Basic Settings Page Parameters (Continued)
Parameter Description
To Next Page
Loading...
