5-73
Chapter 5: Web Based Management Utility
While associating different ports to VLANs, you can also configure INGRESS FILTERING
(at the port level) and A
CCEPTABLE FRAME TYPES (accept Tagged Frame Alone or All
frames).
The other configurations provided in this page are, enabling/disabling per Port MAC
based classification and Port Protocol based classification, enabling/disabling of
tunneling and enabling/disabling of STP BPDU Tunneling. To enable STP BPDU
Tunneling on an interface, you must first enable tunneling on that interface. Users can
configure the Access VLAN, Trunk port allowed VLANs and the Trunk Native VLAN.
Static VLANs
Clicking the STATIC VLANS tab brings up the STATIC VLAN CONFIGURATION page
(Figure 5-57), which allows you to configure the VLAN related information statically.
Using the first table you can create new entries for uncreated VLANs. VLAN ID is the
mandatory field in configuring a VLAN. You can also enter a VLAN N
AME, TAGGED PORT
L
IST, UNTAGGED PORT and the FORBIDDEN PORTS for a VLAN.
The second table displays the VLAN configurations saved in the switch.
Figure 5-57. Static VLAN Configuration Page
To Next Page
Loading...
