1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-26
MAC ACL
Clicking the MAC ACL tab brings up the MAC ACL CONFIGURATION page (Figure 5-16),
which displays the various parameters to configure the MAC Access List. The
parameters for this page are shown in Table 5-10.
Figure 5-16. MAC ACL Configuration Page
Table 5-10. MAC ACL Configuration Page Parameters
Parameter Description
ACL ID
This specifies the unique ID for the access list. Valid range is 1 to 32768. The
factory default is blank.
Source and
Destination MAC
This specifies both the Source MAC Address and Destination MAC Address, for
which the access list must be applied. Both the Source and Destination MAC
Addresses must be configured for the status of the access list to be active. The
factory default is blank.
Action
This specifies the action to be taken for the access list. The factory default is
Permit.
• Permit: Forwards packets which meet the ACL criteria.
• Deny: Drops packets which meet the ACL criteria.
• Redirect: Forces packets which meet the ACL criteria to specified port.
Redirect Port
This specifies the selected ports that packets meeting ACL criteria can be
redirected to. Ports can be provided as a range (for example Gi0/1 or Ex0/1).
The factory default is Gi0/1.
To Next Page
Loading...
