5-27
Chapter 5: Web Based Management Utility
IP Standard ACL
Clicking the IP STANDARD ACL (Access Control List) tab brings up the IP STANDARD ACL
C
ONFIGURATION page (Figure 5-17), which displays the various parameters to configure
the Standard IP access lists. The parameters for this page are shown in Table 5-11.
Priority
The priority of the L3 filter is used to decide which filter rule is applicable when
the packet matches with more than one set of filter rules. The higher value of
“Filter Priority” implies a higher priority. The valid value is 1 to 255, and the
factory default is 1.
VLAN ID This specifies the VLAN ID for which the access list has to be applied.
Port List (Incoming)
This specifies the incoming physical ports, if this ACL has to be ports specific.
(For example Gi0/1-10 or Gi0/1). The factory default is blank.
Encapsulation
This specifies the encapsulation type in the packet. It could be any value
between 1 and 65535. The factory default is blank.
Protocol
This chooses the protocol type to be checked in the packet to apply this ACL.
The factory default is blank.
Figure 5-17. IP Standard ACL Configuration Page
Table 5-10. MAC ACL Configuration Page Parameters (Continued)
Parameter Description
To Next Page
Loading...
