Suzuki AN650 2002 - Reassembly and Remounting

DRIVE TRAIN 4-7
REASSEMBLY AND REMOUNTING
• Install the gears and final driven gear hub onto the final gear
case cover.
• Install the dowel pins
1 and the new gasket.
• Apply SUZUKI SUPER GREASE “A” to spline of the final
drive gear.
W 99000-25010: SUZUKI SUPER GREASE “A”
• Assemble the final gear case.
• Tighten the final gear case bolts to the specified torque.
! Final gear case bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Apply SUZUKI SUPER GREASE “A” to the bearing.
• Install the bearing to the drive shaft.
W 99000-25010: SUZUKI SUPER GREASE “A”
• Install the final gear case assembly.
• Tighten the rear shock absorber mounting bolt.
! Rear shock absorber mounting bolt:
29 N·m (2.9 kgf-m, 21.0 lb-ft)
• Install the speedometer sensor
2 and harness guide 3.
• Tighten the speedometer sensor bolt to the specified torque.
! Speedometer sensor bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
Apply grease to the O-ring of speedometer sensor before install-
ing the sensor to the final gear case.