FUEL SYSTEM AND THROTTLE BODY 7-23
THROTTLE CABLE ADJUSTMENT
NOTE:
Minor adjustment can be made by the throttle grip side adjuster.
(2-18)
TP SENSOR ADJUSTMENT
• After checking or adjusting the throttle valve synchronization,
adjust the TP sensor positioning as follows:
• After warming up engine, adjust the idling speed to 1 200 ±
100 rpm.
• Stop the warmed-up engine and connect the special tool to
the dealer mode coupler. (6-24)
[ 09930-82710: Mode select switch
• Turn the special tool’s switch ON.
• If the TP sensor adjustment is necessary, loosen the TP sen-
sor mounting screw.
• Turn the TP sensor and bring the line to middle.
• Tighten the TP sensor mounting screw.
! TP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
FUEL INJECTOR REMOVAL
• Remove the front box. (9-18)
• Disconnect the injector couplers.
• Remove the fuel delivery pipe assembly. (7-17)
• Remove the fuel injectors No.1 and No.2. (7-17)
FUEL INJECTOR INSPECTION
The fuel injector can be checked without removing it from the
throttle body.
Refer to page 6-40 for details.
• Check the fuel injector filter for evidence of dirt and contami-
nation. If present, clean and check for presence of dirt in the
fuel lines and fuel tank.
FUEL INJECTOR INSTALLATION
• Apply thin coat of the engine oil to new injector seals and
O-rings.
• Install the injector by pushing it straight to the throttle body.
Never turn the injector while pushing it. (7-21)
Incorrect
Correct position
Incorrect
To Next Page
Loading...
