7-10 FUEL SYSTEM AND THROTTLE BODY
FUEL MESH FILTER INSPECTION AND
CLEANING
If the fuel mesh filter is clogged with sediment or rust, fuel will
not flow smoothly and loss in engine power may result.
Blow the fuel mesh filter with compressed air.
NOTE:
If the fuel mesh filter is clogged with many sediment or rust,
replace the fuel filter cartridge with a new one.
FUEL LEVEL GAUGE INSPECTION
Measure resistance between the terminals when the float is at
the position listed below.
[ 09900-25008: Multi-circuit tester
If the resistance measured is out of the specification, replace the
gauge with a new one.
Fuel meter inspection (10-27)
Fuel level position Resistance between terminals
130 mm (F) 11 – 13 Ω
ΩΩ
Ω
82 mm (½) Approx. 71.5 Ω
ΩΩ
Ω
23 mm (E) 130 – 150 Ω
ΩΩ
Ω
130 mm
82 mm
23 mm
F
E
Ò
To Next Page
Loading...
