COOLING AND LUBRICATION SYSTEM 8-7
• Remove the four fixing places and the heat shield.
RADIATOR REMOUNTING
Install the radiator and the radiator hoses in the reverse order of removal.
Pay attention to the following points:
• Connect the fan motor lead wire coupler.
• Tighten the drain plug to the specified torque.
! Drain plug: 6 N·m (0.6 kgf-m, 4.3 lb-ft)
• Pour engine coolant. (2-21)
• Bleed air from the cooling circuit. (2-21)
RADIATOR RESERVOIR TANK
REMOVAL/REMOUNTING
• Remove the reservoir tank mounting bolt.
• Disconnect the siphon hose from the reservoir tank and drain
engine coolant.
• Install the reservoir tank in the reverse order of removal.
• Fill the reservoir tank to the upper level line.
To Next Page
Loading...
