9-84 CHASSIS
When remounting the brake master cylinder onto the handle-
bars, align the master cylinder holder’s mating surface
A with
the punch mark
B on the handlebars and tighten the upper bolt
7 first.
! Master cylinder mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
• After touching the brake hose union pipe to the stopper,
tighten the brake hose union bolt to the specified torque.
! Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
BRAKE-LOCK ADJUSTMENT
Before adjusting the brake-lock, perform to bleed the air from
the rear brake system.
• Pull the brake-lock lever by one step (one notch).
NOTE:
* The brake-lock lever has eight steps (eight notches) when pull-
ing in full.
* When pulling the brake-lock lever, first the brake-lock switch
makes sound, then notch makes a sound. Make a count of
notch by sound except the brake-lock switch’s sound.
• Loosen the locknut
1 and the adjust bolt
2.
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the
master cylinder. (2-25)
To Next Page
Loading...
