CHASSIS 9-85
• Turn the adjuster bolt
2 clockwise until it stops.
• Tighten the locknut
1 to the specified torque with the adjust
bolt
2 held in that position.
! Brake-lock adjust locknut: 9.5 N·m (0.95 kgf-m, 7.0 lb-ft)
NOTE:
Do not turn the adjust bolt more than the given position, or the
adjust bolt may be damaged.
• Inspect the brake lock. (2-33)
BRAKE-LOCK CABLE REPLACEMENT
• Remove the right side leg shield. (9-12)
• Remove the front box. (9-18)
• Loosen the locknut
1.
• Disconnect the brake-lock cable
2.
• Remove the brake hose clamp on the swingarm.
• Remove the locknut
3.
• Remove the brake-lock arm
4 from the caliper.
• Disconnect the brake-lock cable
5 by removing the E-ring
6.
To Next Page
Loading...
