CVT 5-11
• Remove the shim
1 and O-ring
2.
CVT INSPECTION
PRIMARY PULLEY INSPECTION
• Check that the primary pulley faces are free from any greasy
substance.
• Inspect the primary pulley faces for any abnormal conditions
such as scratches or stepped wear.
• If any damages are found, replace the primary pulley assem-
bly with a new one.
• Replace the O-ring with a new one.
SECONDARY PULLEY INSPECTION
• Inspect the secondary pulley faces for any abnormal condi-
tions such as scratches or stepped wear.
• If any damages are found, replace the primary pulley assem-
bly with a new one.
• Check that the secondary pulley faces are free from any
greasy substance.
If the surface is found greasy, make sure to degrease
it thoroughly.
If the surface is found greasy, make sure to degrease
it thoroughly.
To Next Page
Loading...
