7-22 FUEL SYSTEM AND THROTTLE BODY
• Install the IAC hose connector.
• Apply thin coat of the engine oil to the new O-ring.
• Install the synchronizing screw to the original setting by turn-
ing the screw in until it lightly seats, and then backing it out
the same number of turns counted during disassembly.
• Apply thin coat of the engine oil to the new O-ring.
THROTTLE BODY INSTALLATION
Installation is in the reverse order of removal. Pay attention to
the following points:
• Connect the throttle pulling cable and throttle returning cable
to the throttle cable drum.
• Adjust the throttle cable play with the cable adjusters.
Refer to page 2-19 for details.
THROTTLE BODY CLAMP POSITION
Replace the O-ring with a new one.
Replace the O-ring with a new one.
10˚
Forward
Backward
Intake pipe side
#1 #2
#1 #2
Air cleaner side
IAC hose
Top mark
LH RH
VIEW OF TOP
To Next Page
Loading...
